![]() ![]() ![]() Create An “audio” Groupįirst, let’s check to see if your system already has an audio group: If you’d like, you can do this before continuing:īe sure to say “yes” when it asks if you want to enable realtime process priority:Īfter jackd2 is installed, you can skip to “Add Users To “audio” Group” below. Note: Ubuntu/Debian can set up a properly configured audio group for you when you install jackd2. To give a user that power, we create an “audio” group, give that group some special privileges, then add the user to that group. “audio” GroupĪudio software needs to run at a higher priority and with memory locked so that it doesn’t swap out to the hard disk. It’s still a good idea to read the whole thing as there are many helpful troubleshooting tips sprinkled throughout. If you would prefer a faster, more GUI approach, start with the “audio” Group section, then jump to the qjackctl and Qsynth sections, then go back to the Virtual MIDI Keyboard section and read to the end. We will get to the GUI stuff near the end. The GUI can introduce new bugs, so it’s more reliable to work with the command line tools. The reason for this is that it reduces the amount of software that is running which has two advantages: performance and reliability. This is a very command-line-intensive tutorial. This document has been tested with Ubuntu 14.10. This guide is intended to help ease the transition. The problem is that you’ve got to understand a lot about Linux to get started. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |